The Model B is the complete cue maker's workshop. The Model B will perform any and all steps necessary to make the cues of your dreams. Set-up for basic turning chores to tapering shafts, cutting points, installing joints is quick. Solid cast base and precision-machined carriage assures accuracy to ten-thousandths of an inch. A completely variable speed motor takes you through roughing or finishing steps without hesitation. If you could have only one machine in your shop, this one would have to be the one! After all the Model B Q-Lathe was engineered and built specifically for the cue maker by a cue maker who knew what it took. Includes warranty against defects for one year on parts and labor.
Dimensions: 62" L x 15" W x 13" H
Weight: 150 lbs. (approx.)
Motor size: 1/3 HP; 90 volt DC
Power Req.: 115 Vac/60 hz.
Speed: Variable 0-3200 RPM
Through Hole: 1.350"
2000 Model B Q-Lathe Components:
Drill Chuck with key
3 Jaw Bison Chuck with key
Face Knife
2 Alignment Collets
3 QPins; 3/8-10, 5/16-14, 5/16-18
2 Adjustable Collets
1 Butt Collet
1 Joint Collet
1 Wrap Holder
X-Y Tool Post
Router & Attachment w/V Groove & straight blades
Taper Bar with micrometer adjustment
Indexing Lock
1 Dead Center
2 Live Centers
1 Steady Rest
Variable Speed Foot Control
Tip Centering Tool, 14 mm
Shaft Collets; 13, 13.5 & 14 mm
1 Tip Touch
1 Sanding Block
VHS or DVD Instructions
The Model B Q-Lathe can be factory built to meet foreign voltage requirements upon request.
Only $4,295.00 each!
|
|
Click here for a close-up photo of this product.
|
